Skip to content

Method StatementACT-131-MSR00Available

MV Cable Installation and Testing Method Statement

MV Cable Installation and TestingElectrical

ACT-131 / MS / R00

MV Cable Installation and Testing Method Statement

Fictional demonstration project: SiteQuality Courtyard. Adapt to the approved project documents before use.

Scope and project location

  • Activity: MV Cable Installation and Testing. Discipline: Electrical.
  • Applicable work limits / project / area / grid / exclusions: ____________________

Approved references and technical limits

  • Drawing and revision / specification clause / approved ITP: ____________________
  • Approved engineering design / manufacturer procedure / technical limits / project instructions where applicable: ____________________
  • Permits / isolations / specialist and authority releases as applicable: ____________________

Responsibilities and resources

  • Supervisor / specialist lead / safety lead / QC / consultant witness: ____________________
  • Materials and equipment: MV cables, pulling gear and specialist test instruments.
  • Approved submittals / equipment IDs and calibration: ____________________

Prerequisites and work sequence

  • Prior-work release / interfaces / access / pre-task briefing: ____________________
  • 1. Verify cable and certified accessories.
  • 2. Witness approved pull and terminations.
  • 3. Get test release.

Inspection stages and required records

  • Checks and evidence: Drum lengths, pulling log and pre-energisation certificates.
  • Before / during / final inspection: area, acceptance clause, frequency, hold or witness point and record reference: ____________________
  • Nonconformance / corrective action / retest reference: ____________________

Approval

  • Prepared by / reviewed by / approved by / signatures and dates: ____________________

Preview shown in full. The downloaded DOCX, XLSX and PDF are generated from this record.

Other documents for this activity

3