Skip to content

Inspection and Test PlanACT-095-ITPR00Available

Chilled Water Piping Installation — Inspection and Test Plan

Chilled Water Piping InstallationHVAC

ACT-095 / ITP / R00

Chilled Water Piping Installation — Inspection and Test Plan

Fictional demonstration project: SiteQuality Courtyard. Adapt to the approved project documents before use.

Inspection and Test Plan worksheet
Inspection stageCriteria / clauseFrequencyResponsibilityIntervention pointEvidence
Coordinate route and expansion—————
Install and joint—————
Verify drain and vent positions—————

Work identification

  • Project / area / grid: ____________________
  • Approved method, drawing and specification revisions: ____________________
  • Equipment and materials in scope: chilled-water pipe, guides, anchors and valves

Inspection sequence

  • Coordinate route and expansion
  • Install and joint
  • Verify drain and vent positions

Inspection controls

  • Joint traceability, slopes, supports and pressure release
  • Enter the approved acceptance clause, inspection frequency, responsible party and hold or witness point for each stage.
  • Project review and approval: ____________________

Preview shown in full. The downloaded DOCX, XLSX and PDF are generated from this record.

Other documents for this activity

3