Skip to content

Inspection and Test PlanACT-092-ITPR00Available

Ductwork Fabrication and Installation — Inspection and Test Plan

Ductwork Fabrication and InstallationHVAC

ACT-092 / ITP / R00

Ductwork Fabrication and Installation — Inspection and Test Plan

Fictional demonstration project: SiteQuality Courtyard. Adapt to the approved project documents before use.

Inspection and Test Plan worksheet
Inspection stageCriteria / clauseFrequencyResponsibilityIntervention pointEvidence
Verify class and shop sizes—————
Fabricate and seal sections—————
Install supports before closure—————

Work identification

  • Project / area / grid: ____________________
  • Approved method, drawing and specification revisions: ____________________
  • Equipment and materials in scope: duct sections, flanges, sealants and hangers

Inspection sequence

  • Verify class and shop sizes
  • Fabricate and seal sections
  • Install supports before closure

Inspection controls

  • Duct sizes, joints, clearances and leakage release
  • Enter the approved acceptance clause, inspection frequency, responsible party and hold or witness point for each stage.
  • Project review and approval: ____________________

Preview shown in full. The downloaded DOCX, XLSX and PDF are generated from this record.

Other documents for this activity

3